how in the world would you scratch build hinges in 1/35???
I know there are a lot of sizes, but what I'm baffled about is the joint!

If you want a fixed pin then just use a piece of brass wire to depict the pin. With opening hinges I use thin brass strip and roll one end around a thin brass wire.

cheers
Cliff

Kyo-Jin
I think you may need to post a rough sketch of what you require, and then more of us can help you!
Cheers
Brad

here you go. sorry it took sooo long

note the incompletely removed sprue still clinging onto the hinge, causing it to sit lower than it is really supposed to.

Hello jinithith2,
here's is one way of doing a hinge. It works pretty good, and you may have to try it a few times till you get it where your happy. You can find round rod at a local hobby shop under the name of Evergreen or Platistruct. You may even use round sprue, just stretch it with low heat to the size you need. All you have to do then is to drill out the ends. Hope this helps some. Post your hinges when your done, love to see them.

Here is one I quickly made up for you to see, just by using what I explaned above.

*blink blink*.. Thanks for that tip Joe.. My eyes are watering just looking at it... :-) .. I think I like the med tape one better though...


Dave