Militaria Forum
For discussions on a range of topics like reenacting, vehicle restoration, and collecting.
Third Reich combat helmets
Monte
Visit this Community
Rhode Island, United States
Member Since: December 08, 2002
entire network: 833 Posts
KitMaker Network: 216 Posts
Posted: Friday, April 28, 2006 - 10:02 AM UTC
Again I tip my hat at your collection Cody. Most impressive.

I'd be thrilled to have a chance to buy the helmets you turn down!
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Friday, April 28, 2006 - 07:44 PM UTC
Monte,

Try this site. Many of the world's more advanced TR helmet collectors frequent the place. http://daggers.infopop.cc/eve/ubb.x/a/frm/f/2583025185

Cody

Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, May 27, 2006 - 12:32 AM UTC
Waffen SS M-42sd, ckl64, 1943-dated liner. Hardly mint though eminently presentable. Collectors of Waffen SS helmets make distinctions between makers as the SS shield will usually vary with the maker, at least, on real helmets. This example sports the expected 2nd-pattern shield applied at the ckl(ET) factory.

In 1993, the helmet came out of Allentown, PA from a fellow who had owned it for over 40 years previous.

Cody

DOJO
Visit this Community
Georgia, United States
Member Since: January 29, 2005
entire network: 318 Posts
KitMaker Network: 296 Posts
Posted: Thursday, June 01, 2006 - 02:10 PM UTC
If I can ask. What will be a book about helmets?
As don't want to make a mistake when will be building a figure.
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Friday, June 02, 2006 - 07:40 PM UTC
Should you seek color photos of Wehrmacht helmets, Tom Kibler and Bob Iqbal's latest volume would be a good choice.

Cody

DOJO
Visit this Community
Georgia, United States
Member Since: January 29, 2005
entire network: 318 Posts
KitMaker Network: 296 Posts
Posted: Saturday, June 03, 2006 - 12:58 AM UTC
THank you.
Can you please tell me who is publishing this book and ISBN if you have it.
I just need it to place an order from the company that I always order from.
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, June 03, 2006 - 01:47 AM UTC
You can buy direct from one of the authors - http://rfimd2000.tripod.com/

Cody
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Sunday, June 25, 2006 - 06:01 AM UTC
HR M-42sd, ckl64, likely unissued. The little white specks are not housepaint splatter, but, rather, aluminum oxide showing through the paint. Aluminum oxide particles were mixed with the paint to provide texture. For a brief period, ET(ckl) used a very coarse, if not downright chunky, medium for texturing. The paint pigment wore off the texture quite easily during this time. These oddly textured helmets are the exception rather than the rule.

Cody

blaster76
Visit this Community
Texas, United States
Member Since: September 15, 2002
entire network: 8,985 Posts
KitMaker Network: 2,270 Posts
Posted: Saturday, July 01, 2006 - 02:30 AM UTC
I bought one in the early- early 70's. Had a liner, had been repainted and I got ahold of some decals to put on. Probably left over from Spain It looks like the 1940 version, but I think the leather liner inside has been replaced as it doesn't have holes and the tie together is a lot thicker.
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, February 17, 2007 - 09:38 PM UTC
Been a while since adding a new one to the gathering...

HR M-40sd, ET64, 1942 dated linerband.

Cody
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, February 17, 2007 - 09:40 PM UTC
M-40sd ET64 liner.
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, February 17, 2007 - 09:43 PM UTC
HR M-42sd hkp(SE)64, linerband is far too oxidized to discern a date, but, as the manufacturer code is stamped hkp rather than SE, while still retaining a single decal, the date of manufacture was more than likely 1943.

Cody
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Saturday, February 17, 2007 - 09:44 PM UTC
HR M-42sd hkp64 liner.
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Friday, March 16, 2007 - 05:51 AM UTC
The folks at Historicus Forma asked me to prepare what eventually became an introduction to Third Reich helmets. The presentation has as much technical info as I dared to include for an article intended for the model-builder. The link - https://hfmodeling.kitmaker.net//features/1421

Cody
markm
Visit this Community
California, United States
Member Since: September 11, 2005
entire network: 1,757 Posts
KitMaker Network: 590 Posts
Posted: Friday, March 16, 2007 - 06:06 AM UTC
Thanks for posting that, goes along really well with this original post. I have learned more about the helmets here than anywhere else. You have a fantastic collection
Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Sunday, May 27, 2007 - 07:42 PM UTC
Well, I honestly thought I had the willpower to retire from collecting Third Reich combat helmets. Apparently, I'm weak.

Oh well, here is a much sought-after helm...snake-leg variation of the early Luftwaffe M-35dd. Unlike most early Lufts, the liner in the helmet is not copiously marked with some unit ID.

Hope you enjoy,
Cody

Stahlhelm
Visit this Community
Oregon, United States
Member Since: April 03, 2004
entire network: 414 Posts
KitMaker Network: 0 Posts
Posted: Sunday, May 27, 2007 - 07:52 PM UTC
Another helmet which came from the same deal as which produced the previous snake-leg...

Never thought I would ever own one of these as they are not something to which I had ever paid any attention whatsoever. Having now owned an example for a bit of time the thing has sorta' grown on me.

ET68 paratrooper helmet. Like Heer helmets wartime-issued Luftwaffe para helmets were painted in the olive-drab shade of schiffergrau. This example was produced during the transition time from pre-war gear to wartime economy equipment as the linerband is still the early aluminum while the liner pads are wartime hardware. As per the 1940 order requiring removal of the tri-color shield, a single decal of the Luftwaffe has been applied to the shell.

Cheers,
Cody

Lucky13
Visit this Community
Scotland, United Kingdom
Member Since: June 01, 2006
entire network: 1,707 Posts
KitMaker Network: 530 Posts
Posted: Sunday, May 27, 2007 - 11:29 PM UTC
WOW! That is an impressive collection mate! Is there a helmet floating about that you'd give your arm and one leg for??
JeepLC
Visit this Community
Virginia, United States
Member Since: June 20, 2007
entire network: 510 Posts
KitMaker Network: 40 Posts
Posted: Monday, August 20, 2007 - 04:32 PM UTC
Hey all! I was given a Hitler youth helmet by my great uncle. He took it off of a 15 year old near Bastogne (along with his kit and K98 which I also have now). I have some more stuff like bayonets and SS hunting knives. I think the German stuff is cool but my favorite things come from my family who served in the Pacific. I have a USMC Raider combat knife that was given to me by my grandfather. It is not very rare or expensive but means the most.

You have an amazing collection there Cody. I dream of one day having such a collection (let alone a place to put it!). It is amazing to me the shape they are in. Have you done cleaning or repainting at all? Those look like they just rolled off the line!

Thanks for showing us your stuff.
-Mike
goldenpony
Visit this Community
Zimbabwe
Member Since: July 03, 2007
entire network: 3,529 Posts
KitMaker Network: 422 Posts
Posted: Tuesday, August 21, 2007 - 06:18 AM UTC
That is a fantastic collection of helmets you have. Over the years I had a couple, but I was into the dealing end at the time and never kept any. Now of course looking back I wish I had.

Thank you for sharing.