_GOTOBOTTOM
Modeling in General: Health and Safety
Have a question about what is safe or an experience that might warn others?
Hosted by Jim Starkweather
Rustall
PanzerKarl
Visit this Community
England - North West, United Kingdom
Member Since: April 20, 2004
entire network: 2,439 Posts
KitMaker Network: 283 Posts
Posted: Friday, June 11, 2004 - 11:15 PM UTC
Got my rustall today is there any safety points that i should take ie contact with skin and such like thanks all
kglack43
Visit this Community
Alabama, United States
Member Since: September 18, 2003
entire network: 842 Posts
KitMaker Network: 0 Posts
Posted: Friday, June 11, 2004 - 11:25 PM UTC
gee...i dunno...maybe the INSTRUCTIONS would tell you...personally, theres one place i would keep it far away from...nothing worse than a 'Rusty-Nail '

hehe
Sealhead
Visit this Community
Kansas, United States
Member Since: May 18, 2003
entire network: 427 Posts
KitMaker Network: 0 Posts
Posted: Saturday, June 12, 2004 - 02:58 AM UTC
Rustall is rust in a carrier. Rust is iron-oxide. Like all chemicals, play it safe. Don't inhale it. Keep it away from cuts, etc.

I don't think it is a very hazardous chemical, but treat it with respect and don't dump it down the drain. If the rust is gone or the carrier is gone, you can buy or make more.

Sealhead
 _GOTOTOP