Hi All,
I wodered if its possible to thin Milliput?
I have the fine stuff and when, according to the instructions, I mix the two parts the result is ok but is very thick and stiff. Its ok for big things, but useless for small filling duties.
Can it be thinned to get a consistency more like thick yoghurt, rather than tyre rubber?
Thanks and cheers
Peter
:-)
Hosted by Jim Starkweather
Milliput question...?
flitzer
England - North West, United Kingdom
Member Since: November 13, 2003
entire network: 2,240 Posts
KitMaker Network: 677 Posts
Member Since: November 13, 2003
entire network: 2,240 Posts
KitMaker Network: 677 Posts
Posted: Monday, March 15, 2004 - 06:20 PM UTC
piwi
Nord, France
Member Since: March 15, 2004
entire network: 712 Posts
KitMaker Network: 150 Posts
Member Since: March 15, 2004
entire network: 712 Posts
KitMaker Network: 150 Posts
Posted: Tuesday, March 16, 2004 - 12:26 AM UTC
Hi ,
Why don't you try to drop a little bit of acetone ?
It works to obtain a mastic more fluid !
Bye
Why don't you try to drop a little bit of acetone ?
It works to obtain a mastic more fluid !
Bye
mikeli125
England - North West, United Kingdom
Member Since: December 24, 2002
entire network: 2,595 Posts
KitMaker Network: 1,079 Posts
Member Since: December 24, 2002
entire network: 2,595 Posts
KitMaker Network: 1,079 Posts
Posted: Tuesday, March 16, 2004 - 01:44 AM UTC
can't you just use water to thin it down? I've tried it and seemed ok but I cant roll long thin lines for weld beads to save my life!
flitzer
England - North West, United Kingdom
Member Since: November 13, 2003
entire network: 2,240 Posts
KitMaker Network: 677 Posts
Member Since: November 13, 2003
entire network: 2,240 Posts
KitMaker Network: 677 Posts
Posted: Tuesday, March 16, 2004 - 01:45 AM UTC
Thanks piwi,
have nail polish remover in stock...Mrs Flitzer does I should say...
Thanks again
Cheers
Peter
:-)
have nail polish remover in stock...Mrs Flitzer does I should say...
Thanks again
Cheers
Peter
:-)