I'm finishing a Monogram Classics P51 Mustang and the decals disintegrate on touch.
I'm putting a couple drops of dish soap in the water and using Micro Set.
But the things are falling apart with the slightest touch of brush, finger, or scalpel edge.
Is there a way to mitigate this short of buying third party decals?
Thanks!
Hosted by Jim Starkweather
how do you deal with fragile decals?
discordian
New Jersey, United States
Member Since: May 28, 2009
entire network: 239 Posts
KitMaker Network: 38 Posts
Member Since: May 28, 2009
entire network: 239 Posts
KitMaker Network: 38 Posts
Posted: Wednesday, June 10, 2009 - 05:51 AM UTC
AJLaFleche
Massachusetts, United States
Member Since: May 05, 2002
entire network: 8,074 Posts
KitMaker Network: 2,574 Posts
Member Since: May 05, 2002
entire network: 8,074 Posts
KitMaker Network: 2,574 Posts
Posted: Wednesday, June 10, 2009 - 06:09 AM UTC
I've had Micro Set kill early Monogram decals. Get some MicroScale Decal Saver/decal Film and treat the decals before immersing them. That might help. Dishwashing detergent? Never heard of that for decal work.
discordian
New Jersey, United States
Member Since: May 28, 2009
entire network: 239 Posts
KitMaker Network: 38 Posts
Member Since: May 28, 2009
entire network: 239 Posts
KitMaker Network: 38 Posts
Posted: Wednesday, June 10, 2009 - 07:04 AM UTC
Never heard of that... cool. I have some old models (70's) whose decals would benefit from that if I build them!
as far as the dish soap - it something I used to do years ago. just a drop or two.
as far as the dish soap - it something I used to do years ago. just a drop or two.
dioman13
Indiana, United States
Member Since: August 19, 2007
entire network: 2,184 Posts
KitMaker Network: 356 Posts
Member Since: August 19, 2007
entire network: 2,184 Posts
KitMaker Network: 356 Posts
Posted: Wednesday, June 10, 2009 - 12:50 PM UTC
I had testor old ambulance and the decals slivered completly. When I wrote to Testors they kindly sent me a new set and advised me to sray them with a light shot of clear coat. You have to cut them out real good but it stopped the slivering of the decals. They snuged right down with solv-a-set.