_GOTOBOTTOM
Modeling in General
General discussions about modeling topics.
Hosted by Jim Starkweather
cleaning flux paste
godfather
Visit this Community
Canada
Member Since: June 26, 2002
entire network: 817 Posts
KitMaker Network: 148 Posts
Posted: Sunday, May 27, 2007 - 01:39 PM UTC
I soldered some tubes to a base but have found that some flux paste has remained in between the tubes. What is the best way to clean this off before I paint?
Sandy
Visit this Community
England - East Anglia, United Kingdom
Member Since: June 24, 2002
entire network: 628 Posts
KitMaker Network: 212 Posts
Posted: Sunday, May 27, 2007 - 03:15 PM UTC
hi , the answer is a good wire brush to scrub it out , be careful as you can undo all the good work , slow and sure is the answer , cheers ian
 _GOTOTOP