Buy, Sell or Trade
This forum is for all selling and buying related topics.
This forum is for all selling and buying related topics.
Hosted by Jim Starkweather
Precision cutting board???
ti
Dalarnas, Sweden
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Posted: Saturday, December 30, 2006 - 02:58 AM UTC
I have always had to cut using my eye as a guide to try and get the exact measurements but it's hard. Especially if you have to cut so many pieces and come to find out you're 5 ieces that are short of your prescribed measurements. My question is where can I fins a precision cutting board when cutting styrene here in Sweden?? Maybe else where??? Thanks.
Posted: Saturday, December 30, 2006 - 03:05 AM UTC
There are different mats available that have markings and measurements on them. Panduro has a few, I think I have even seen them at Claes Ohlsson and Biltema. They are the "self-healing" type that cost around 100 SEK each. Hope this helps!
ti
Dalarnas, Sweden
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Posted: Saturday, December 30, 2006 - 03:33 AM UTC
Thanks Brian. i'll take a look but tere is one that I think is more robust. It's call the chopper II, I think. Has anyone heard of it??
Posted: Saturday, December 30, 2006 - 03:45 AM UTC
OK!! I thought my answer was too obvious. I don't know if you can find it in Sweden, but Micro-Mark has it. I have ordered things from them before without any hassle what so ever.
Micro-Mark Search for Chopper II and you will find what you are looking for!
Micro-Mark Search for Chopper II and you will find what you are looking for!
ti
Dalarnas, Sweden
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Posted: Saturday, December 30, 2006 - 03:52 AM UTC
Thanks.
matt
Campaigns Administrator
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Saturday, December 30, 2006 - 04:42 AM UTC
Duplicutter II I have a Duplicutter I and I love it for doing sheet cuts
ti
Dalarnas, Sweden
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Member Since: May 08, 2002
entire network: 2,264 Posts
KitMaker Network: 254 Posts
Posted: Saturday, December 30, 2006 - 10:54 AM UTC
Thanks Mat. How much did it cost you?
matt
Campaigns Administrator
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Saturday, December 30, 2006 - 09:37 PM UTC
IIRC it was about 30USD I see the new one is still around that as well.