Community Forum: Filipino Modelers Phorum
Want to meet up with modelers in your country or region? This is the place.
Want to meet up with modelers in your country or region? This is the place.
Hosted by Jim Starkweather
Alternative modeling epoxy putty
BriannB
Luzon, Philippines
Member Since: July 04, 2006
entire network: 2 Posts
KitMaker Network: 0 Posts
Member Since: July 04, 2006
entire network: 2 Posts
KitMaker Network: 0 Posts
Posted: Friday, July 28, 2006 - 02:25 AM UTC
Help po. Does anyone know any modeling epoxy putty available here in the Philippines? I'ver tried Pioneer marine epoxy putty but it starts curing in 2 minutes. I'm looking for one that is workable for at least 1 hour or so before curing or hardening.
shonen_red
Metro Manila, Philippines
Member Since: February 20, 2003
entire network: 5,762 Posts
KitMaker Network: 2,610 Posts
Member Since: February 20, 2003
entire network: 5,762 Posts
KitMaker Network: 2,610 Posts
Posted: Friday, July 28, 2006 - 02:05 PM UTC
You could use:
1. Milliput - expensive. Available at JMN at Harrison's
2. Sculpey - not as expensive as milliput. Requires baking. Check any Hobe's branch.
3. Tamiya putty
That's weird. Last time I used Pioneer putty, it didn't cure in just 2 mins. Maybe you didn't mix/mend the putty well?
1. Milliput - expensive. Available at JMN at Harrison's
2. Sculpey - not as expensive as milliput. Requires baking. Check any Hobe's branch.
3. Tamiya putty
That's weird. Last time I used Pioneer putty, it didn't cure in just 2 mins. Maybe you didn't mix/mend the putty well?