As the title says, I need advice on mounting models to bases. I have a wooded base covered with vinyl spackle mixed with dirt and ground cover. What is the best method for mounting my model, an M4 Sherman, to the base?

Thanks in advance.

I usually glue mine down with CA. If you are planning on moving it around a lot, to shows, etc, you may want to consider bolting it to the base.

Shaun

I either glue mine to a base or if the kit needs more support i tend to drill and pin the model to the base i have done this for tanks, figures and aircraft.

^ditto^

The method you use will depend on the handling and movement of the project.

Low movement projects for me sometimes get as little as PVA.
High maint kits will get a hole and bolt treatment.
Medium deals get resin or a wire loop drilled up through the base and wrapped around an axle.