Hosted by Jim Starkweather
ATAK Zimmerit where can I get some?
Vadster
Tennessee, United States
Member Since: June 28, 2004
entire network: 987 Posts
KitMaker Network: 0 Posts
Member Since: June 28, 2004
entire network: 987 Posts
KitMaker Network: 0 Posts
Posted: Monday, July 17, 2006 - 07:43 AM UTC
I'm looking for the set that fits the DML Tiger 1 Late. I have tried Great Models, Model Point, Models by Mickster...all nada.
spongya
Associate Editor
Budapest, Hungary
Member Since: February 01, 2005
entire network: 2,365 Posts
KitMaker Network: 474 Posts
Member Since: February 01, 2005
entire network: 2,365 Posts
KitMaker Network: 474 Posts
Posted: Monday, July 17, 2006 - 10:38 PM UTC
Why don't you try some putty or soldering iron? Both of them are surprisingly easy and very good-looking. (And cheap...)
WildCard
Texas, United States
Member Since: May 23, 2005
entire network: 945 Posts
KitMaker Network: 0 Posts
Member Since: May 23, 2005
entire network: 945 Posts
KitMaker Network: 0 Posts
Posted: Monday, July 17, 2006 - 11:12 PM UTC
Hey brother,
Have you thought of using Cavalier zimmerite instead? Not that I have a brand preference but I think Atak zimm are really hard to find in the states. Besides, Cav zim is cheaper too (most of the time about $10 less). You can always do the zimm yourself but I find that it's not worth the time/money/energy, so I only do it manually whem it is required.
try to look for Atak on ebay with no luck but here's what I found:
eBay
I know its not for DML, but some of my models with zimm are not intended for the it for its brand use. You just need to use a very little bit of putty and the result is still great. I hope this helps.
WC
Have you thought of using Cavalier zimmerite instead? Not that I have a brand preference but I think Atak zimm are really hard to find in the states. Besides, Cav zim is cheaper too (most of the time about $10 less). You can always do the zimm yourself but I find that it's not worth the time/money/energy, so I only do it manually whem it is required.
try to look for Atak on ebay with no luck but here's what I found:
eBay
I know its not for DML, but some of my models with zimm are not intended for the it for its brand use. You just need to use a very little bit of putty and the result is still great. I hope this helps.
WC