Hosted by Jim Starkweather
Enlarging turret race-what's best way?
generalzod
United States
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Posted: Friday, June 02, 2006 - 12:49 AM UTC
What's the best way to enlarge the turret race on a Sherman upper hull? I need to do so on a DML hull I am adding the Tamiya Pershing turret to it I have a Dremel tool I just want to get the opening even so the turret doesn't sit too far forward or backward
Posted: Friday, June 02, 2006 - 01:11 AM UTC
If you only need to remove a little material,I'd use either a rat tail or half-round file.If major chewing is required, I would scribe the line and then use the round drum sanding sleeves in the Dremel kit to get close to the line.Then finish it off by hand file.
cheers!
cheers!
generalzod
United States
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Posted: Friday, June 02, 2006 - 01:19 AM UTC
Rick
Thanks The Pershing turret is 8mm or so wider I got some major chewing to do :-)
Thanks The Pershing turret is 8mm or so wider I got some major chewing to do :-)
Dixon66
New Hampshire, United States
Member Since: December 12, 2002
entire network: 1,500 Posts
KitMaker Network: 154 Posts
Member Since: December 12, 2002
entire network: 1,500 Posts
KitMaker Network: 154 Posts
Posted: Friday, June 02, 2006 - 01:24 AM UTC
Chad,
Do you know anyone that has a set of hole saw blades? There may be one that is close enough in size to cut the hole. Just back the race with a piece of wood and spin the drill real slow.
My $0.02
Dave S.
Do you know anyone that has a set of hole saw blades? There may be one that is close enough in size to cut the hole. Just back the race with a piece of wood and spin the drill real slow.
My $0.02
Dave S.
generalzod
United States
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Member Since: December 01, 2001
entire network: 3,172 Posts
KitMaker Network: 612 Posts
Posted: Friday, June 02, 2006 - 01:32 AM UTC
Quoted Text
Chad,
Do you know anyone that has a set of hole saw blades? There may be one that is close enough in size to cut the hole. Just back the race with a piece of wood and spin the drill real slow.
My $0.02
Dave S.
Dave
Offhand I don't The turret race on the Pershing is just under 2 inches That is a good thought though When I get home later this month I will check around