_GOTOBOTTOM
Modeling in General: Advice on...
Need some general advice? Place it here.
Hosted by Jim Starkweather
removing over spray from clear parts
pfc
#333
Visit this Community
Oklahoma, United States
Member Since: October 13, 2002
entire network: 1,017 Posts
KitMaker Network: 189 Posts
Posted: Tuesday, July 19, 2005 - 12:59 PM UTC
Does any one have a techniqe for removing over spray from clear part. I not sure what it was painted with so I need a tip for both water based paint and enamel.
Probuilder
Visit this Community
Colorado, United States
Member Since: January 10, 2005
entire network: 193 Posts
KitMaker Network: 0 Posts
Posted: Tuesday, July 19, 2005 - 01:12 PM UTC
Castrol SUPER clean. won't harm clear parts, just soak it from an hour to overnight. works everytime and is none toxic
pfc
#333
Visit this Community
Oklahoma, United States
Member Since: October 13, 2002
entire network: 1,017 Posts
KitMaker Network: 189 Posts
Posted: Tuesday, July 19, 2005 - 01:17 PM UTC
Thanks Probuilder, were might I find this product.
18Bravo
Visit this Community
Colorado, United States
Member Since: January 20, 2005
entire network: 7,219 Posts
KitMaker Network: 981 Posts
Posted: Tuesday, July 19, 2005 - 01:29 PM UTC
If you can't find that, try tarter control toothpaste, followed by Novus plastic polish. Novus is available in most plastics dealerships, and the occasional motorcycle shop.
Probuilder
Visit this Community
Colorado, United States
Member Since: January 10, 2005
entire network: 193 Posts
KitMaker Network: 0 Posts
Posted: Wednesday, July 20, 2005 - 09:15 AM UTC
You can get it at Wal-mart or almost any uto supply store . Bravo's right too ! and you can get novus at the same sources .
 _GOTOTOP