hello,i have the aber grill set for my jagdpanther sd.kfz.173.[italeri].i put the screens in place that fit,but there are some other parts left??.is this for a other type of jagdpanther[early one] or............and where do the chains go??
can someone help me with this.......thank you

Yep... those larger screens fit to the 'early' model jagdpanther...

Later,
Tim

ok ,thank you.but what about those chains,or are they a [extra]..

The chains are, I think, part of the larger set, the full set for the jagdpanther, which I have. Going by it's instructions this gives the following:

You might have forgotten the small circle (under the vent in the center near the hammer).

The 16 chains (2x8) are used to keep the horseshoe-shaped thingies on tn their pins, and the spare tacklinks in place (marked V). The ones marked VIII might be used for keeping the towing-cables in place on the rear deck and the toll normally stored right above the hammer and crow-bar if stored on the side.
Part VI is used as a chain for holding the plug used when the machinegun was removed from the ballmount.

To see for yourself:

Aber-site. For the instructions, go to instructions, then plates. It is set 35028.

Hope this helps,

Harm

that helps a lot,thank you harm