_GOTOBOTTOM
Modeling in General: Advice on...
Need some general advice? Place it here.
Hosted by Jim Starkweather
Epoxy problem....
Art
Visit this Community
Michigan, United States
Member Since: March 20, 2004
entire network: 604 Posts
KitMaker Network: 0 Posts
Posted: Thursday, September 16, 2004 - 09:55 PM UTC
If I can't find the solution here, then there is none, so here's the question: How to remove hardened epoxy from a metal figure. Thanx.

Art
DaveCox
Visit this Community
England - South East, United Kingdom
Member Since: January 11, 2003
entire network: 4,307 Posts
KitMaker Network: 788 Posts
Posted: Thursday, September 16, 2004 - 10:07 PM UTC
If you can get a sharp blade under the edge then you can often just 'pop' the epoxy off. Otherwise carve it away and clean up the area.
 _GOTOTOP