Where can I find this tool? Ive looked for it every were but cant find it. Any help would be great.....

Here is a pic of what i am looking for:

Matrix,

VLS carries it, I think. Check the link. I think it is what you are after.

Shaun

https://www.modelmecca.com/cgi-bin/shop.pl?go=Search&partnumber=GF%20350

Yes thats it! Thanks a million!!

ignorant question - does the nut come out hex shaped?

Im not sure, i havent seen it up close but if not you could drill a small hole and insert some plastistruct rod......

Matrix - that's why I asked - if it's round, just drill holes in a metal sheet and make your own.

I saw an article about these somewhere. There are different sizes for hex nuts and conical rivets. I think the one to make the hex nuts is basically a thick piece of PE with a nut shaped hole etch into it. Heat the plastic and jam it down in the hole, pull it out and shave off the nut.


HTH,

Shaun

Oh my bad i missread the question slodder, yes it does come out hex shaped. I thought you ment does the bolt show through the nut.......but yes it does come out hex shaped.