_GOTOBOTTOM
Modeling in General
General discussions about modeling topics.
Hosted by Jim Starkweather
Warpage of thin resin and how to fix it
Wolf-Leader
Visit this Community
New Hampshire, United States
Member Since: June 06, 2002
entire network: 1,225 Posts
KitMaker Network: 463 Posts
Posted: Wednesday, July 03, 2002 - 02:31 AM UTC
I would like to know how do you fix thin pieces of resin that have been warped from glueing other pieces of resin and sheet plastic to it?
Red4
Visit this Community
California, United States
Member Since: April 01, 2002
entire network: 4,287 Posts
KitMaker Network: 824 Posts
Posted: Wednesday, July 03, 2002 - 03:15 AM UTC
Low heat, pressure, patience, and then cold water to set it......helps if you have roughly 32 hands too...lol... If you can find some body to help use the first 4 steps and you 're good. I use hot water when "fixing" this type of stuff. Hope this helps ya' "Q"
Wolf-Leader
Visit this Community
New Hampshire, United States
Member Since: June 06, 2002
entire network: 1,225 Posts
KitMaker Network: 463 Posts
Posted: Wednesday, July 03, 2002 - 04:25 AM UTC
Thanks Matt, See you tonight.
 _GOTOTOP