_GOTOBOTTOM
Tips & Tricks
Ask about and post about tips and tricks you use while modelling.
Hosted by Jim Starkweather
Tool cleaning after using epoxy putty
Tanksami
Visit this Community
Victoria, Australia
Member Since: August 06, 2011
entire network: 1,314 Posts
KitMaker Network: 25 Posts
Posted: Friday, January 27, 2017 - 02:48 PM UTC
Hi Guys,
I have some of the "newish" Tamiya two part epoxy putty that I am going to use for making Zimmert, but have no idea what to use for cleaning up of my Zimmert tools when done?
Had no luck googling for an answer
Cheers Mike
Pave-Hawk
Visit this Community
Western Australia, Australia
Member Since: May 05, 2006
entire network: 900 Posts
KitMaker Network: 92 Posts
Posted: Friday, January 27, 2017 - 03:07 PM UTC
Generally I have found that epoxy putties can be cleaned up with water, or at worst isopropyl alcohol, if the epoxy is not allowed to dry.

Once dry, generally only mechanical removal is possible, i.e. scraping, sanding etc.
Tanksami
Visit this Community
Victoria, Australia
Member Since: August 06, 2011
entire network: 1,314 Posts
KitMaker Network: 25 Posts
Posted: Friday, January 27, 2017 - 03:29 PM UTC
Hi Iain,
Thanks for that I have both so will give it a try.
Cheers Mike
Vicious
Visit this Community
Queensland, Australia
Member Since: September 04, 2015
entire network: 1,517 Posts
KitMaker Network: 309 Posts
Posted: Saturday, January 28, 2017 - 03:44 AM UTC
Maybe you can try acetone
 _GOTOTOP