_GOTOBOTTOM
Modeling in General
General discussions about modeling topics.
Hosted by Jim Starkweather
Smallest of the drill bits?
GazzaS
#424
Visit this Community
Queensland, Australia
Member Since: April 23, 2015
entire network: 4,648 Posts
KitMaker Network: 189 Posts
Posted: Friday, March 04, 2016 - 03:05 AM UTC
Hi everyone,
I have two set of drill bits, each costing approximately 20$. My problem is, that most of the ones .5mm and smaller have broken over time. I really don't want to buy another whole set when I only need a couple of bits.

Does anyone know of a maker of solitary bits I might seek and try to source locally?

Thanks!

Gary
CMOT
Staff MemberEditor-in-Chief
ARMORAMA
Visit this Community
England - South West, United Kingdom
Member Since: May 14, 2006
entire network: 10,954 Posts
KitMaker Network: 1,873 Posts
Posted: Friday, March 04, 2016 - 04:46 AM UTC
If you go into a decent tool shop you should be able to purchase packs of 10 down to .5mm and order in the others also in packs of 10.
GazzaS
#424
Visit this Community
Queensland, Australia
Member Since: April 23, 2015
entire network: 4,648 Posts
KitMaker Network: 189 Posts
Posted: Friday, March 04, 2016 - 05:21 AM UTC
Thanks Darren!

Gary
 _GOTOTOP