Hosted by Jim Starkweather
1/32 Special Hobby P-39F
plasticpilot
Australia
Member Since: June 02, 2015
entire network: 1 Posts
KitMaker Network: 1 Posts
Member Since: June 02, 2015
entire network: 1 Posts
KitMaker Network: 1 Posts
Posted: Wednesday, June 03, 2015 - 01:08 PM UTC
I am building a Special Hobby 1/32 P-39F. The instructions are a bit vague. Where does the clear piece representing the armoured glass behind the pilot's seat sit inside the frame-arch? In the centre or flush at the rear. Have had a look at a few "walk-around" sites, but not sure.Thanks for any replies.
Posted: Wednesday, June 03, 2015 - 02:33 PM UTC
Jason I can't help you with your question but you may get more help if you post this in the aircraft part of this network rather than general modelling.
Top left of your screen is a button marked 'Browse sites' click this and a drop down box will appear, click on Aeroscale and your then in the aircraft section. Good luck with your issue.
Top left of your screen is a button marked 'Browse sites' click this and a drop down box will appear, click on Aeroscale and your then in the aircraft section. Good luck with your issue.