does anyone know how to make scale soda cans

I have no expirence in doing so, but I suppose a dowel rod and perhaps a decal to go around it?

sounds good
what size do they make

It would depend on what sixe dowel rod you use, the come in many sizes, just find one to fit your scale

hi this is the easiest thing to make , you need alumium foil see my article of replacement rack guards , a multi turreted hole punch get one from a leather store or shoe repaire shop and plastic card , punch out a suitable dia of plastic card you will need at least 40 thousands of an inch for the base , then cut a stip of aluminium foil the correct height , and roll it round the base to form a tube , leave a tiny bit at the rear to form a seal ,super glue the tube to the base and you have a hollow true aluminium soda can , you can also punch out the same dia in aluminium and pop it inside and you do not need to paint internaly , all you do then is detail on the outside , these can be made in any scale from 1/35 to 1/9 just needs application and trial and error . the same method can be used for buckets or trash cans just needs a wire handle cheers ian

Thankz that really helped me!!!

Nick