_GOTOBOTTOM
Modeling in General: Advice on...
Need some general advice? Place it here.
Hosted by Jim Starkweather
Debonding cynoaquilate glue without damaging
Chuck4
Visit this Community
United States
Member Since: November 13, 2013
entire network: 403 Posts
KitMaker Network: 2 Posts
Posted: Tuesday, August 12, 2014 - 01:48 AM UTC
Is there a way to safely debond cynoaqualate glue joint without softening the plastic?
matt
Staff MemberCampaigns Administrator
Visit this Community
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Tuesday, August 12, 2014 - 01:54 AM UTC
That's the danger using the debonder (Acetone) you never know if the plastic will or won;t soften..
Chuck4
Visit this Community
United States
Member Since: November 13, 2013
entire network: 403 Posts
KitMaker Network: 2 Posts
Posted: Friday, August 15, 2014 - 01:38 AM UTC
Is there anything else that would debond cynoaqualate without softening or ruining plastic?
chumpo
Visit this Community
United States
Member Since: August 30, 2010
entire network: 749 Posts
KitMaker Network: 225 Posts
Posted: Friday, August 15, 2014 - 04:26 AM UTC
You could try putting the piece in the freezer , maybe if frozen the super glue will fracture and be easier to remove . Just an idea .
retiredyank
Visit this Community
Arkansas, United States
Member Since: June 29, 2009
entire network: 11,610 Posts
KitMaker Network: 3,657 Posts
Posted: Friday, August 15, 2014 - 06:24 AM UTC
I've used oven cleaner, with great success. But, your safest method would be to put it in the freezer.
 _GOTOTOP