_GOTOBOTTOM
Modeling in General: Advice on...
Need some general advice? Place it here.
Hosted by Jim Starkweather
1/32 scale seamless intakes
outlaws
Visit this Community
California, United States
Member Since: August 01, 2005
entire network: 27 Posts
KitMaker Network: 3 Posts
Posted: Saturday, June 28, 2014 - 01:02 PM UTC
Where can I buy 1/32 scale seamless intakes for Tamiya's F4J?
(Cutting Edge, DMold, or Seamless Suckers)
Any help would be appreciated.
RolyPoly
Visit this Community
United Kingdom
Member Since: October 20, 2010
entire network: 38 Posts
KitMaker Network: 2 Posts
Posted: Monday, June 30, 2014 - 12:10 AM UTC
I bought mine from Seamless Suckers - your best bet is to look on ebay. I found them quite difficult to source if I remember correctly. If you buy the seamless suckers intakes, beware that some minor modification will be required to get them to fit the kit properly - its a simple fix requiring the use of some 0.5mm styrene rod.
 _GOTOTOP