_GOTOBOTTOM
Tools & Supplies
Discussions on the latest and greatest tools, glues, and gadgets.
Hosted by Matt Leese
Drill Bits Converting Between MM and Inch
JPTRR
Staff MemberManaging Editor
RAILROAD MODELING
#051
Visit this Community
Tennessee, United States
Member Since: December 21, 2002
entire network: 7,772 Posts
KitMaker Network: 802 Posts
Posted: Thursday, April 10, 2014 - 01:13 AM UTC
http://webpages.charter.net/sinkwich/sdventure/html/sd_drill_index.htm
matt
Staff MemberCampaigns Administrator
Visit this Community
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Thursday, April 10, 2014 - 01:19 AM UTC
You can also request Drill & Tap info as well as metric equivalent charts from LS Starrett

http://www.starrett.com/catalogs

I have PDF Versions of them saved PM me an email address if you'd like them.
chumpo
Visit this Community
United States
Member Since: August 30, 2010
entire network: 749 Posts
KitMaker Network: 225 Posts
Posted: Thursday, April 10, 2014 - 12:28 PM UTC
Careful gentlemen , next thing is you are going to need a micrometer because the drill bits got mixed up .
matt
Staff MemberCampaigns Administrator
Visit this Community
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Thursday, April 10, 2014 - 12:51 PM UTC

Quoted Text

Careful gentlemen , next thing is you are going to need a micrometer because the drill bits got mixed up .


Already have that covered... but then with sherline machines you neet the propper measuring tools
 _GOTOTOP