_GOTOBOTTOM
Tools & Supplies
Discussions on the latest and greatest tools, glues, and gadgets.
Hosted by Matt Leese
"how to" paint stand/small part holder
fhvn4d
#159
Visit this Community
Massachusetts, United States
Member Since: April 07, 2008
entire network: 803 Posts
KitMaker Network: 132 Posts
Posted: Monday, May 23, 2011 - 03:17 AM UTC
Hello all! with all the great things I have seen on here, I thought I would add my latest project. It started out life as a paint stand. Its a lazy susan bought from the local department store. 10 inch diameter.


Then grabbed some 12/3 wire from a home improvement project and randomly cut it up. Strip the outside insulation and you get 3 pieces of wire for each.


Add in some aligator clips from just about any hardware/ department store....



and finally drill some holes in the top and sides of "suzi", and insert as shown.... makes a nice addition to the workbench and It cost me about 10 bucks to make it!
ProfessorP
Visit this Community
Minnesota, United States
Member Since: February 20, 2007
entire network: 339 Posts
KitMaker Network: 9 Posts
Posted: Tuesday, May 31, 2011 - 04:19 PM UTC
Hey, that looks pretty handy. Thanks for sharing.
 _GOTOTOP