Hi everybody
Has any one used the Tamiya product MARK FIT as a decal setting solution?
If so.....how is it used and how was the results?
Thanx
Kind regards
Henk
Hosted by Jim Starkweather
Decal setting solution
henkman
Gauteng, South Africa
Member Since: October 12, 2005
entire network: 44 Posts
KitMaker Network: 8 Posts
Member Since: October 12, 2005
entire network: 44 Posts
KitMaker Network: 8 Posts
Posted: Tuesday, November 24, 2009 - 07:31 AM UTC
Bigrip74
Texas, United States
Member Since: February 22, 2008
entire network: 5,026 Posts
KitMaker Network: 461 Posts
Member Since: February 22, 2008
entire network: 5,026 Posts
KitMaker Network: 461 Posts
Posted: Tuesday, November 24, 2009 - 06:13 PM UTC
Hello Henk:
I have not used Tamiya MARK FIT so I cannot help you there. I use vinegar diluted with just a little water, it does a pretty good job and does not cost much. Hope this helps you.
Robert
I have not used Tamiya MARK FIT so I cannot help you there. I use vinegar diluted with just a little water, it does a pretty good job and does not cost much. Hope this helps you.
Robert