_GOTOBOTTOM
Modeling in General
General discussions about modeling topics.
Hosted by Jim Starkweather
Radio Equipment
CaptainJack
Visit this Community
Luxembourg, Belgium
Member Since: March 17, 2002
entire network: 793 Posts
KitMaker Network: 0 Posts
Posted: Friday, April 19, 2002 - 09:06 AM UTC
Can somebody obtain images for me of the new US radio equipment? This way we could look at producing a set to install in modern vehicle models.

Thanks
Captain Jack
CaptainJack
Visit this Community
Luxembourg, Belgium
Member Since: March 17, 2002
entire network: 793 Posts
KitMaker Network: 0 Posts
Posted: Friday, April 19, 2002 - 02:36 PM UTC
Forgot to sat I was looking for photos of the sincgars, VRC-90 and newer, smallerr system. Any dimensions would also be gratly appreciated.

Jack
Epi
Visit this Community
Texas, United States
Member Since: December 22, 2001
entire network: 3,586 Posts
KitMaker Network: 453 Posts
Posted: Friday, April 19, 2002 - 03:08 PM UTC
Jack,
I can take some pictures for you, but I wont be able to till I have drill. It wont be until the 17, 18, and 19 of May. We just got our SINGAR mounts installed a couple of months ago.
CaptainJack
Visit this Community
Luxembourg, Belgium
Member Since: March 17, 2002
entire network: 793 Posts
KitMaker Network: 0 Posts
Posted: Friday, April 19, 2002 - 07:20 PM UTC
:-) Great Epi thanks ,for that


Jack :-)
ARENGCA
Visit this Community
Arizona, United States
Member Since: February 13, 2002
entire network: 382 Posts
KitMaker Network: 101 Posts
Posted: Saturday, April 20, 2002 - 11:38 AM UTC
No dimensions, but check the HMMWV section in the gallery. I posted a bunch of pictures I took two weeks ago. They show the current "Foxtrot" series VRC-89/90, and the racks and shelf. If you have any specific questions, I can try to answer them.
CaptainJack
Visit this Community
Luxembourg, Belgium
Member Since: March 17, 2002
entire network: 793 Posts
KitMaker Network: 0 Posts
Posted: Saturday, April 20, 2002 - 06:38 PM UTC
I will be starting the project shortly to produce this accessory set. hopefully I'll have enough information to start now. Thanks again guys. I'll let you know as soon as the kit is done and produced; still need dimensions but Epi is on to that. I also require a good rear shot of the unit to rack attachment configuration if possible.

Jack at your service
 _GOTOTOP