I was wondering what you all would suggest on how to make a name plate to add to a wooden base. I read somewhere that somehow, one could create the name plate on the computer, then transfer it to a brass plate using an iron as a heat source. I'm not sure how well this would work, or if it even does. What would you all suggest? It doesn't have to be brass, but it would look nice if it was.

Thanks!

Any trophy shop can make one for you. Unless you had some sort of transfer material, like the iron stuff they use for t-shirts, an iron won't transfer anything.

I had this plate engraved at a local engraving/trophy shop. One thing that helps is to have it typed out like you want it on a sheet of paper before you go into the shop. They can do almost anything that you can imagine if it is a good shop.

Hi Jordan. For a relatively cheap and simple method, where you can choose your own text, fonts, etc, see the explanation by Pete Herrera on TimeLines. Ive used it on my last few dios, and it works well. Click here
Below are some examples of how I used it.

I make my own nameplates using thin brass plate or stainless steel plate ( available from model railway section) which I cut to size with scissors, then apply rub-on dry transfer lettering and finally coat with Future floor polish to protect the lettering and stop the brass from tarnishing.

You could also print the letters from computer onto clear self-adhesive labelling and stick it onto the plate .

Doing it this way is a bit fiddly, but far cheaper!

Hey Brent, you know that the word 'missile' on your plate has been missspelt don't you?

Unbelieveable. I can't believe I didn't notice. Dang.

Thanks for bringing that to my attention.

I don't know if I can get that plate to come off to replace it.

Maybe it would be safer to simply stick a new plate right over the top of this one? But first show it to the engraver to get a refund!

Craig Whitaker did a similar feature over on HF. See here: Quick 'n Easy Name Plates

Rudi