_GOTOBOTTOM
Scratchbuilders!: General
For general topics on scratchbuilding.
Hosted by Mike Kirchoff
Parts casting
SgtYoungblood
Visit this Community
United States
Member Since: February 06, 2008
entire network: 6 Posts
KitMaker Network: 0 Posts
Posted: Friday, February 08, 2008 - 08:37 AM UTC
What is the thinest casting agent?
KoSprueOne
Visit this Community
Myanmar
Member Since: March 05, 2004
entire network: 4,011 Posts
KitMaker Network: 879 Posts
Posted: Friday, February 08, 2008 - 09:18 AM UTC
The two part epoxy resin. This is also a very general question, so I assume you refer to the resin option?




slodder
Visit this Community
North Carolina, United States
Member Since: February 22, 2002
entire network: 11,718 Posts
KitMaker Network: 2,584 Posts
Posted: Friday, February 08, 2008 - 05:34 PM UTC
If youre talking about viscosity the thinnest one I have used is the two part casting resin from MicroMark, the next one is hobby casting resin from ACMoore, then more paste/putty stuff like tube epoxy.
SgtYoungblood
Visit this Community
United States
Member Since: February 06, 2008
entire network: 6 Posts
KitMaker Network: 0 Posts
Posted: Saturday, February 09, 2008 - 09:14 AM UTC
I need something that will pour like water, I had been using a dental polymer but have ran out .I had got a five gallon bucket of the resin but only had a quart of the hardener
matt
Staff MemberCampaigns Administrator
Visit this Community
New York, United States
Member Since: February 28, 2002
entire network: 5,957 Posts
KitMaker Network: 2,626 Posts
Posted: Saturday, February 09, 2008 - 06:10 PM UTC
the Smooth on Family has some resin that pours like water..........
 _GOTOTOP