_GOTOBOTTOM
Modeling in General: Advice on...
Need some general advice? Place it here.
Hosted by Jim Starkweather
Using Excel to make MRE boxes?
sgtreef
Visit this Community
Oklahoma, United States
Member Since: March 01, 2002
entire network: 6,043 Posts
KitMaker Network: 1,603 Posts
Posted: Monday, June 11, 2007 - 01:24 PM UTC
Hi trying to make MRE boxes in Excel.

does this look correct?

Plus how do I know if size is correct.

Learning it I am trying



Thanks all
goldstandard
Visit this Community
California, United States
Member Since: March 29, 2007
entire network: 208 Posts
KitMaker Network: 0 Posts
Posted: Monday, June 11, 2007 - 05:50 PM UTC
If you are trying to control the size at which the boxes print out, I would recommend using Word. There is a ruler at the top which can act as a reference, which I think one of the people here who uses an ALPS printer prefers.
sgtreef
Visit this Community
Oklahoma, United States
Member Since: March 01, 2002
entire network: 6,043 Posts
KitMaker Network: 1,603 Posts
Posted: Monday, June 11, 2007 - 09:55 PM UTC
Thanks will look into word.
 _GOTOTOP